Baytech MMP units controller Reset Procedures Manual do Utilizador descarregar pdf

ModularControllerResetProcedure



1),Removethe(5)screwfromthe

faceplate,RedArrows

2),UseEXTREMECAUTION:if

powerisappliedtounit,Pull

controllerouttorevealthe

connector,

RedArrow.

Pressthesmalltabincenterof

connectortoreleasethe

connectorfromthecircuitboard.

RedArrow

ProductionControllerresetsteps:ThisstepwillNOTaffectthestateoftheoutlets.

1. Use a paper clip or similar object, Press and hold a micro-switch in the hole next to the (SEL) button

under the LCD screen or between 2

& 3

LED (BLUE Arrow) disconnect the cable to the module for

5 seconds, (RED Arrow)

2. Continue to press micro-switch, connect cable to module, wait 10 seconds and release switch.

3. Serial in to the module. If it appears the controller did not reset, still contains old data, perform reset

again but increase the disconnect time to 10 seconds and wait time to 15 seconds.

Resumo do Conteúdo

Página 1

ModularControllerResetProcedure1),Removethe(5)screwfromthefaceplate,RedArrows2),UseEX

Modelos relacionados MRP units controller Reset Procedures | MSP units controller Reset Procedures |

Comentários a estes Manuais

Sem comentários

Baytech MMP units controller Reset Procedures Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Hardware de computador Baytech MMP units controller Reset Procedures. BayTech MMP units controller Reset Procedures User Manual Manual do Utilizador

Resumo do Conteúdo

Modelos relacionados MRP units controller Reset Procedures | MSP units controller Reset Procedures |

Comentários a estes Manuais